- Need Help Guage Problem
- Best Tranny for the Job
- Advice needed
- Gauge mask kit installed!
- Boost, Wastegates, Bleed and EGT's
- HKS BOV flange pattern
- Cooler Temp Spark Plug for 2000 RST
- 2.2l performance?
- TEC-II not showing any injector info
- Successful EJ20 swaps
- Help
- Is stock WRX fuel pump good upgrade for RS?
- Cheapest standalone ECU?
- 2.5 oil pressure locations
- Power FC enough to run with a turbo RS?
- Any last bit of advice from the wise?
- What to call a Supercharged 2.5RS?
- Exhaust question
- Turbo charger for 2.5 motor (outback sport)
- Ludespeed Turbo Install Directions
- Another Fuel Pressure Question!
- Pictures of WRX and RS exhaust pipes?
- few Q's
- Evo 5 Acceleration Problems in 3rd gear up
- Fuel Pump Relay Question
- Finally everything is here!
- Anyone know where to get an EJ20?
- Flat 6 Swap and Turbo
- EJ20 in a 2000 2.5 RS
- broken speedo after turbo install
- Engine managment? How's about this --
- Injectors for a 2.2L NA engine?
- Price for a TEC3?
- My newest turbo setup !
- Turbo rebuild kit?
- Little help
- Has anyone installed the Vishnu turbo kit yet?
- stroker kit -->full boost sooner?
- The definition of turbo lag
- LHD to RHD wiring
- WRX Piping on GC8
- any 60mm gauge pod or A-pillar for GC8?
- Can you say OUCH!...check it out.
- Boost and valve float?
- Questions about Ludespeed Stage 1
- best place for EGT probe
- turbo plans
- Garrett or anyone know if the EFI system a/f gauge is wide or narrow band?
- Part number for 02 WRX OEM intercooler?
- A-pillar dual gauge pod for OBS?
- My car is Dyno-tuned!
- MY93-MY97 interior Gauge Placement?
- this has probably been beat down too much
- I think this may be helpful
- 2k Impreza RS: which oxy wires Tec2-3
- Too much power
- turboing 1.8 litre
- I need TEC 3 install instructions!! Anybody?
- New observations about our fuel pressure regulators and RRFPR's!
- Link ECU ?'s
- Looking for information on engine build
- Looking for some info
- Defi Gauge Question
- For those that don't have a stock FPR, what did you put in its place?
- STi Ver 6 forged pistons in '94 WRX?
- turbo people NY?
- suppose I....
- Update on my FPR stuff. some interesting info inside.
- Air/Fuel Mixture Gauge?
- Head gaskets for 90-93 EJ20 turbo (Liberty RS?)
- Running on 3 Cylinders, any pointers?
- Knock Sensor Part Number
- Legacy Engine Swap
- NOS vs Turbo
- OK need some help!
- What to do next?
- Is a closed deck necessary
- Preparing to Install the Link 2
- EGT installed, but how do I seal the threads? They leak!
- low max boost pressure in ludespeed II kit
- Save your self time, frustration, and money and just get a SVX FPR!
- Interest in SOHC valve springs?
- Eaton SuperCharger
- blowing oil through a turbo?
- Got my Vishnu Turbo today!
- Super Chargers
- home brew turbo?
- Important: what size feed and return line is everyone running ?
- Link plus and A/F ratio gauge?
- must??
- Tranny vs HP
- Link2 and Link Plus the same thing?
- Maximum HP on stock RS fuel system with walbro fuel pump
- Link 2 question
- TEC-II Kit: Pardon my ignorance, but what the heck
- Help - Split Second - Timing Map Controller
- Can't make up my mind
- Start RPM on a drag?
- STi Redline?
- Pictures of my screwed up piston!
- Did I install my A/F gauge right?
- Can't create more than 3lbs of boost.
- Did you use the following compound for your turbo kit?
- Centrifugal blower?
- Speedo Sending Unit
- EJ20T swap or Turbo?
- Pro ECM and aftermarket turbo
- Need Advice
- broken voltage clamp = no prob.
- what are my timing control options?
- Piston Upgrade Path
- My Frankinstien MAF... pics
- WRC exhaust manifold?
- Hks Turbo Timer Wiring Instructions
- 2.5 L = bored and stroked 2.2 L
- Need help with HKS wastegate problem
- my new turbo
- whats needed for turbo
- Difference between vf22 and t3/t4
- I need some help!
- Have a turbo, now what do I do?
- Greddy type-s BOV question.
- Attn: Shiv! I need a base map. Could you hook me up?
- Anyone tried this airplane computer on their car?
- Discrepancy between boost gauge and S-AFC. anyone?
- EJ22T questions
- USDM wrx swap+ AEM EMS into GC8 best option?
- Where to find 440cc Injectors?
- need help: Adding 2 12v Fans to my Air/Air IC
- turboing
- EJ22T bore & stroke?
- What "settings" are you using on your ITC?
- For anyone that has been having idle problems with the link 2.
- BOV vacuum?
- Help! I need a tial 35mm flange
- How to set up Timing Curve?
- 97 OBS injector upgrade
- can't stop running rich from RRFPR
- little pieces that are needed?
- P170 What does this code mean?
- Greddy Emanage
- My thoughts for closed-loop to open-loop with link.
- Low cost 4 psi of boost
- Sources for IHI turbo inlet flanges?
- Just Found This, PEMS comparison
- GL-10 turbo swap
- Is there a fuel pump between stock and Walbro?
- Minnam TMIC and carbon brace
- Link2 hesitation fix
- FYI: WRX injectors in RS manifolds - No go.
- Turbo map for the link 2
- SR20DET injector quetion
- RS-T vs RS/WRX Stock conversion Dyno Charts
- Pictures of uppipes for autos?
- Aftermarket fuel pump
- RS/WRX conversion drivability?
- VITEK wires?
- 3" stainless mandrel bends
- legacy gt..would this work? what else would i need?
- SR20DET Injectors and Legacy ECU
- Length after the rear tranny mounting bracket
- Parallel fuel mod from ludespeed
- Kit installed. Now there's blue smoke out the exhaust
- Vishnu Oil return line
- JDM engine swap=short driveshaft
- Any 98RS-T with LudeSPEED kit? Photo requested! TIA
- Best spot for BOV with FMIC
- My weekend project
- Any high powered bolt-on kits for RS?
- Homemade turbo timer wiring
- preparation to accept supercharger or turbo
- Link2 users
- Hose & Bolt Sizes
- Turbo installed, now car just won't start; help requested!
- denso injectors
- Need links to NipponDenso sellers
- Greddy Profec B not controlling boost
- about to take the plunge and buy pistons and rods. suggestions wanted.
- Custom Head Gaskets
- Greddy E-manage Question!
- Twin Turbo on the RS
- Rs vs wrx oil pressure
- tec-3 ego sensor problem
- looking for an oil pan
- How to mount the sprayer to cool the intercooler?
- Pipe interchange?
- Piston Oil Squirter Install Instructions?
- Turbo exhaust question:
- My Outback Super Sport
- Help: Need wiring Diagram for EJ22 Turbo ECU
- EGT question, mine are low
- Outback Identity Crisis
- BOV question
- Doing a ver 6 ra swap in 97, 98 or 99 impreza L questions
- Will a jdm ver 6 sti ra engine pass emissions?
- Rallispec in NJ?
- Do I need the stock FPR with a RRFPR?
- .028 gap for spark plug?
- pricing on a wrx engine swap
- Stand alone engine management?
- what spark plug to use?
- Please help- A/F gauge, tried everything
- Best aftermarket clutch?
- Has your car turned/switch off while driving?
- Tranny swap
- HKS Fuel Cut Defender:
- which up-pipe for a 95 1.8 litre auto
- wrx intercooler on GC8
- canīt pass over 4500 rpms
- Calling all engineers
- One month anniversary (Link 2)
- turbo on the 1.8l lsedan ?
- ECU Compatability?
- Ver IV potentially at my disposal
- Turbo project questions
- help, does anyone know where the fuel pump relay is?
- where are all the SC kits at?
- Attn: Rovah
- good idea...will this work?
- SARD FPR question
- DEFI gauges
- and W T F is this ? .. would this actually work?
- sti ver 5 engine swap
- How do you like your turbo kit for 2.5 rs?
- N00b question, how to check for good ground?
- tec-3 iac
- Leaking coolant, help!
- Experiences with USDM WRX engine into GC8?
- Split Second VC2 or proECM?
- To Do List on 2.5RS
- Link Boost Solinoid
- going from N/A to turbo.. Maybe
- turbo picture links fixed
- All this talk of oil squirters got me thinking:
- Rimmer S/C BOV destroyed
- what is the benefit of an adjustable Volt Clamp
- Stock coolant temp sensor
- BSP to NPT fittings source - local USA
- Exhaust: Convince me.
- Fuel pressure and injectors
- 13 PSI with Link, no pinging, fun fun fun...
- Exhaust header with only 2 bolts; what are the dangers?
- LinkPlus Basemap
- Exhaust systems
- A TD04L-13G powered RS joins the turbo ranks...
- EM-3 programable ECU
- Subaru Ej20 2.0 Twin Turbo Engine
- RC Injectors vs. stock intake manifold...
- Skywalker
- Boost Control for AMR LINK2