blueturbo2
06-05-2006, 04:22 PM
I have install ecuflash 1.27, have the openport 1.2 cable, and it is reading it as com4 which is selected on ecuflash.
I try to read the rom from the car with the ignition on selecting 05-06 Subaru DBW STI/WRX/Legacy and it gets an error vaidating the kernal
Anyone know what is going wrong?
Freon
06-05-2006, 04:24 PM
You're probably doing it wrong. Did you connect the green test connector? Did you turn your ignition on JUST before you hit the "ok" on the read rom confirmation dialog box in Ecuflash?
It does sound like your COM port is selected correctly.
colby
06-05-2006, 05:25 PM
Has the car been reflashed at all?
blueturbo2
06-05-2006, 05:43 PM
Got it...the green test connector was not fully clicked together
blueturbo2
06-05-2006, 06:50 PM
I have a second problem now.
It seems to read fine and finishes, however under parameters, there are only two ignition maps (A and B which are exactly the same) and nothing else. Is this an issue with it being an 06 or am I just doing something wrong here
Also, the ecu is stock, no reflash of any kind
west_minist
06-05-2006, 11:30 PM
Can you go to openecu.org and post there w/ the rom.
Thanks
blueturbo2
06-06-2006, 03:25 PM
Done. Its in the reflashing software section