mpaone
06-07-2006, 11:23 AM
I've read through the several technical docs concerning wiring headlights but I just need general info on how the system is wired.
My issue is that all of the pre-existing wires are there but since it's a swap, some of them were bypassed to make things easier.
For example the red lead on the LH headlight is hot but all the rest (LH and RH) are not. all of the current wires and there and the relays click when I turn the column switch, I just need to complete the path.
If someone could please post a description like column switch, x amount of wires go to relay/ fuse, then to x leads on headlight, etc.
FYI, I have the drivers fender off and was going to test continuity on the wires in that harness when I turn the switch but havent got that far yet. It's been difficult to follow routing since the soldered wires from the swap are different colors (i.e. a BG wire under the dash may not be a BG wire in the fender).
TIA!
-Mike.
My issue is that all of the pre-existing wires are there but since it's a swap, some of them were bypassed to make things easier.
For example the red lead on the LH headlight is hot but all the rest (LH and RH) are not. all of the current wires and there and the relays click when I turn the column switch, I just need to complete the path.
If someone could please post a description like column switch, x amount of wires go to relay/ fuse, then to x leads on headlight, etc.
FYI, I have the drivers fender off and was going to test continuity on the wires in that harness when I turn the switch but havent got that far yet. It's been difficult to follow routing since the soldered wires from the swap are different colors (i.e. a BG wire under the dash may not be a BG wire in the fender).
TIA!
-Mike.