heffey
06-10-2006, 05:24 PM
So I installed an Eclipse Navigation AVN5500 in my car about a month ago, and took my time installing everything. Soldered all wires, and made sure I tapped into the correct VSS wire. I left the reverse wire off, and grounded my parking brake wire so I can watch movies in gear.. Anyway so everything is working flawlessly, until a couple of days ago. After I arrived home from my trip ( I did use my cruise control)and now have lost my speedo. The check engine light came on, to tell me this as well.. I think the code reads low input on VSS..
So I checked all my fuses, and everything looks good... Does anyone know of another fuse I could be missing (besides the main fuse box, and second one under the drivers dash?) If not, a fuse I'm thinking now, that I might have cooked my speed sensor, but i need help?
Also. I'm trying to figure why this would have happened at all.. Bad ground???? I grounded the stereo through the existing harness, could this have cause my problem?
Any help would greatly be appreciated...
So I checked all my fuses, and everything looks good... Does anyone know of another fuse I could be missing (besides the main fuse box, and second one under the drivers dash?) If not, a fuse I'm thinking now, that I might have cooked my speed sensor, but i need help?
Also. I'm trying to figure why this would have happened at all.. Bad ground???? I grounded the stereo through the existing harness, could this have cause my problem?
Any help would greatly be appreciated...