....also my dome light does not work when I open my doors.....checked fuses..ok..can turn it on manually though.....anybody.....


thanks :confused:

....orange light on gas gauge = yer almost outa gas.....and the switch on the overhead light has 3 positions.....select one of the other positions----OR....the bulb is bad.....and there is an online woners manual somewhere....mebbe somebody will post that link

Thanks for the feedback, my tank is half full, I think the light or gauge is just acting up, its going off and on now. The dome light works ok, just not when the doors open. It is set on Door on the switch......any info is appreciated.....thanks

Thanks for the feedback, my tank is half full, I think the light or gauge is just acting up, its going off and on now. The dome light works ok, just not when the doors open. It is set on Door on the switch......any info is appreciated.....thanks

....wuz yer car bought used????

yes, I am the third owner, it appears to have been in a wreck in front, fenders are original but hood, bumper and headlights were replaced and probably airbags as well.....

yes, I am the third owner, it appears to have been in a wreck in front, fenders are original but hood, bumper and headlights were replaced and probably airbags as well.....


....and you may have had a few kiddiestupidities added :rolleyes:

ok....can I fix the dome light problem? Where do I start?

ok....can I fix the dome light problem? Where do I start?


PM'd ya ;)

Thanks for the info, which is excellent by the way. Can you help me with one more problem, I just lowered my car, Tein springs, and now my ABS light is on. All sensors look good, no broken wires etc....do I have to go to the dealer to get codes pulled or can like an Autozone pull them......?

Thanks for your time.

Thanks for the info, which is excellent by the way. Can you help me with one more problem, I just lowered my car, Tein springs, and now my ABS light is on. All sensors look good, no broken wires etc....do I have to go to the dealer to get codes pulled or can like an Autozone pull them......?

Thanks for your time.


....junk them springs quick or you WILL regret it!!!!

:rolleyes: ....everybody does.....ya be buyin new struts soon....

....and ya borked something......likely a broken wire or sensor

Autozone can't 'pull' the ABS codes...check the FSM on that one

EDITED:...Misinformation

Well actually if the ABS light is on there will be a code stored in the ABS controller, but Autozone can't read it. There is a procedure in the service manual to read out ABS codes yourself, or you can have a dealer do it (but they will charge you for the diagnostic time).

Thanks for the info everyone