Mr. Sadface
12-21-2006, 12:57 AM
I've got basically a brand new UTEC. I purchased it from PDX Tuning, and then we all realized that it wasn't the thing for my 4EAT. So, we switched right away to EcuTek.
My loss, your gain!
It's currently still bolted up under the pass side floor. But, it's not connected. It's been there for like 3 months...lol.
I should have some time to pull it all out next week.
Asking $500 for it!
Here are the specs:
2004-2005 USDM WRX
Plug-&-Play
No cutting, splicing or additional sensors required
20 minute, do-it-yourself installation
End-user programmable via PC,PDA with HyperTerminal, and our Game Boy and Smart Cable (coming soon)
Fine tune the maps for your exact setup
Pre-programmed base maps get you started quickly and safely
Base maps for our Staged upgrade packages
Five (5) maps plus ?stock mode? selectable with a flick of the switch
Create custom maps for street gas, race gas, nitrous, or whatever
No need to lug around a laptop just to switch between your program
Optional remote swtich (NOT INCLUDED)
Fuel, ignition timing, and boost are programmable in 250rpm increments up to 9000rpm over 10 load sites
Complete ignition timing control
Fuel control
Controlled via MAF sensor signal offset
Tune stock and larger than stock injector
Load reference
MAP (manifold pressure)
Closed loop boost control programmable via Throttle Position and RPM
Knock control
Automatically retards timing when the knock is detected safeguarding against engine damage
Adjustable knock threshold, timing correction, and duration
On board data logging
Built in programmable solenoid controller
Control Nitrous, Water Injection, Intercooler Sprayer etc.
Drag racing launch control (secondary rev limit used during launch)
Free software upgrades
My loss, your gain!
It's currently still bolted up under the pass side floor. But, it's not connected. It's been there for like 3 months...lol.
I should have some time to pull it all out next week.
Asking $500 for it!
Here are the specs:
2004-2005 USDM WRX
Plug-&-Play
No cutting, splicing or additional sensors required
20 minute, do-it-yourself installation
End-user programmable via PC,PDA with HyperTerminal, and our Game Boy and Smart Cable (coming soon)
Fine tune the maps for your exact setup
Pre-programmed base maps get you started quickly and safely
Base maps for our Staged upgrade packages
Five (5) maps plus ?stock mode? selectable with a flick of the switch
Create custom maps for street gas, race gas, nitrous, or whatever
No need to lug around a laptop just to switch between your program
Optional remote swtich (NOT INCLUDED)
Fuel, ignition timing, and boost are programmable in 250rpm increments up to 9000rpm over 10 load sites
Complete ignition timing control
Fuel control
Controlled via MAF sensor signal offset
Tune stock and larger than stock injector
Load reference
MAP (manifold pressure)
Closed loop boost control programmable via Throttle Position and RPM
Knock control
Automatically retards timing when the knock is detected safeguarding against engine damage
Adjustable knock threshold, timing correction, and duration
On board data logging
Built in programmable solenoid controller
Control Nitrous, Water Injection, Intercooler Sprayer etc.
Drag racing launch control (secondary rev limit used during launch)
Free software upgrades