First off this little guy was well worth the wait and money :)

I am running an 06 WRX MT stage 1 and on two seperate pulls in 3rd and 4th gear, I hit 15.6 lbs. of boost. Does that seem a little high (not that I am complaining, just want to make sure everything is running as expected). I was monitoring boost with the AP and its kick*ss realtime guages
Thanks!

Look here (http://www.cobbforums.com/forums/showthread.php?t=32845) for Map downloads and Notes. Judging from your car setup a '06 WRX MT, from the pdf (for 93 octane v101 of the map):

Boost Targets: ~13.5psi +/- 0.7psi peak boost pressure tapering down
to ~9psi, depending on vehicle and conditions. If your vehicle is
not achieving or exceeding the boost targets, you may need to
mechanically adjust your boost control system, please refer to this
document “How Subaru’s Factory Boost Control System Works v1.X” for
instructions.

The document can be found here (http://www.cobbforums.com/forums/showthread.php?t=32552)

it's a little higher than "target" but if you're monitoring DAM/KC and your ECU is happy run it :devil: