Hi everybody, could someone help me out for which I have this code
< P0456 - Evaporative emission control system malfunction >

" A guy told me that "Alot of times, the fault is caused by the Electrical harness in the rear for the Purge Solenoid, by the canister. Sometimes, there is moisture build up, or dirt build up that causes a bad connection on the connector. Or the on the harness, there is a splice inside the loom, and the splice usually corrodes or falls off due to moisture aswell. "

would that be the problem?? if not,can anyone show me a picture of which part i should chk out....thank you.

What car are we talking about here?

+1 to check the gas cap sealing. Then the hoses that go to the solioid and charcol canister for leaks and pinching. I would think the electrical harness would be a very long shot so do the easy first.

it's a 2001 rs coupe 2.5rs....

it's a 2001 rs coupe 2.5rs....

...put that in yer damned profile so we know ya not talkin about a farking Pinto

Considering that I'm a newbie, if u dont want to help, u can go read the next post.

I have replaced a few Purge Solenoid's on a few cars.

really?? is it hard to replace these solenoid?

Considering that I'm a newbie, if u dont want to help, u can go read the next post.

......d000000d.....do NOT get an attitude or ya may get NO(good) help with anything around here.

GOT IT????