went home and popped the trunk and noticed that my case of beer bent my meth line leading to the front of the car.....luckily it was not turned on yet. Getting tuned for it next month.

Any suggestions...

Do SS lines kink or bend?

SS lines are great, just made and installed them on my setup due to a melted line.

SS lines are great, just made and installed them on my setup due to a melted line.

where did you order the ss line from??

slowboy racing sells the line but not the right fittings. I got the fittings from amazon hose here in Orlando and I crimped them myself.

do the SS lines kink though....I need to find some type of solution to my problem.

Here is a picture of the setup and you can see the line on the right side of the unit. The line was kinked.....any options?

http://i16.photobucket.com/albums/b3/brigadoonb/DSCN0027-1.jpg

Have you thought about moving it over to the fender well. You could fab up a bracket to protect the side that the hose comes off of.

do the SS lines kink though....I need to find some type of solution to my problem.

Here is a picture of the setup and you can see the line on the right side of the unit. The line was kinked.....any options?

http://i16.photobucket.com/albums/b3/brigadoonb/DSCN0027-1.jpg

Our stainless lines do not Kink at all. Keep in mind that stainless lines require alot more work for cutting and installation and are not as convenient as the nylon, but they have stainless woven outside and thick teflon inside. Personally, I would install the system in such a way that your hose does not bend or kink, if that is not possible due to your location, stainless would work.