tankerWRX
02-09-2007, 06:07 PM
I reverted to stock using the accessport on my 06 WRX. Now I have a CEL and flashing cruise light, and the car is not running right. I verified the accessport was unmarried correctly ("select map to send to ECU") and disconnected, pumped brakes, and reconnected the battery to reset ECU.
Still nothing. Just CEL and flashing cruise. The car is idling high and won't rev over like 2500 RPM its like its in limp mode or something.
Any Ideas? ECU fried?
Airboy
02-09-2007, 06:36 PM
unhook the green flash connector?
tankerWRX
02-09-2007, 06:44 PM
unhook the green flash connector?
Oh yeah did that too.
Ok, Cliff Notes: I followed COBBs instructions perfectly, tried ECU reset by battery disconnect. Car no run right.
Edit: I installed stage 1 again and it works fine. Strange.
boundy3
02-09-2007, 07:46 PM
What mods do you have to your car, are you back to stock?
Tea cups
02-09-2007, 10:40 PM
Why don't you find out what particular DTC has been thrown?
Airboy
02-10-2007, 01:48 AM
Do you have Version 1 of the AccessPort? I think there is an early batch that would not "revert to stock" correctly that required a patch file to be loaded into the AccessPort.
If that is the case, you'd better give Cobb a call.
Hytorc
02-10-2007, 02:11 AM
Try this.
http://accessecu.com/kb/index.php?ToDo=view&questId=39&catId=3
instructions and patch
tankerWRX
02-10-2007, 02:17 AM
Looks like the problem, my serial number matches the ones with the problem. thanks.