Running 18x8 rota p1's with buddy club coilovers ...they are not even slammed and i am rubbing from the front inner fenders ...i dont know if that'll change once i get my alignment or not..

Thanks!

This is when i am making half turns

And i have both camber settings at zero but it seems like the right side sticks out furthur : ?

so the million $ question is what is the offset of the wheels

48 i believe

sounds like you're too low

I've seen people more slammed then me..:confused:

an alignment will greatly affect the amount of rubbing.. if your at zero right now, and you get like -1.5, thats quite a difference

i doubt you will rub, if you still do, then ya your too low

It's weird though cause ...both of them are set at zero and the right side sticks out furthur from the top and on the left side its more tucked in.

Set at zero what? Camber? That's really bad, you know.

Set at zero what? Camber? That's really bad, you know.

ok yes camber.

I put it at zero just to make it to alignment tomorrow.

what do you mean by half turns?

You mean you set the camber plates to "zero"? That doesn't mean you have zero camber. Did you just install the coilovers?

I am running 18x8 Rota P1's, +48 offset, with 235/40/18 lowered on Tein H-techs and have no rubbing issues at all, even at a full turn in either direction.

How low do you have the coilovers set?

You mean you set the camber plates to "zero"? That doesn't mean you have zero camber. Did you just install the coilovers?


yes i did

Are the tires rubbing on the inside of the fender well, or the outside? I'm guessing the outside?

Are the tires rubbing on the inside of the fender well, or the outside? I'm guessing the outside?


from the inside. im going to get my alignment now....i just raised it up alittle and its fine..