ohk soo i'm routing through my 03 wrx harness and i need some help...

in this picture... the two green connectors are the test mode connectors (B75 & B76) now... the black one and the clear one... which is the flash memory connector (B250)? my print out says that the clear one is... but i was shocked by how big the terminals were... is this rite or is the black one the flash connector?

(btw the black one is said to be the diagnosis connector... B82)


http://i110.photobucket.com/albums/n90/Skatermxracer/EJ205%20engine%20swap/KIF_0853.jpg

sorry about the picture size

look at your schematics and reference wire color as well. If the plug and the wires both match up to the schematics then they are probably right. You could also do a continuity check from the pins on the plug to the pins on the ecu plugs to ensure that the wires that are supposed to be going from B250 to the ecu are the wires that are actually going there. If all of that matches up then you are probably good to go.

flash only needs 2 wires

edit:just looked at my flash block kit 03 should be a 3 pin connector with only 2 pins populated

like so
http://www.tactrix.com/images/0203_WRX_init_connector_smwm.JPG