After installing the USDM LHD steering rack what did you do to get the power steering lines plumed to EJ20k. They are different I think.

Pictures or good explanations welcome.

cheers

garrett

I believe you will have to mock these up. My jdm ps pump and lines mate up differently from my usdm pump and lines. Without the jdm hard lines to run to my pump, I definitely would have had to make some up.

did you try the jdm lines??

easiest way is to take both lines to a hose shop and have them spliced i would bet its at least $100 (fittings were 22)

i have access to a fitting press (snow cat shop at work) so i bought the fittings, will mock it up and then cut it

i did my V4 the way JAXX explains. i used aircraft grade compression fittings to hold the JDM top side(all the way to the lower hard part) to the USDM lower hard lines, and rotated the fittings and lines a bit to keep them from coming close to the header.

mine was free, but i had the flaring tool, and fitting laying around, the knowledge cost me tho!

--keith