This is a newb question so thanks for any help!,
I just purchased a STi block to use with my stock WRX turbo and heads, for the time being... I was wondering if there is a hybrid map made for this kind of aplictation. (2.5 block 2.0 head) That would seem to be the simple fix, rather than trailering the car to the shop to get tuned. If there is a map, can I just download it into the UTEC and then load it prior to starting the car?.Please enlighten me!

Here is a link that some people have used to get going.
http://forums.nasioc.com/forums/showthread.php?t=1128301
I just built myself a hybrid and installed the sti parameters from turboxs.com then I contacted pdx tuning to see if there was a map that they could send me for the break in but they said it would be fine to run it but not to throw any more than waste gate boost at it (11 psi with my 20g). So thats what I did and I just went and got it tuned at pdx last week after 4,000 break in miles and it put down just over 300 whp. Good Luck.

This is a newb question so thanks for any help!,
I just purchased a STi block to use with my stock WRX turbo and heads, for the time being... I was wondering if there is a hybrid map made for this kind of aplictation. (2.5 block 2.0 head) That would seem to be the simple fix, rather than trailering the car to the shop to get tuned. If there is a map, can I just download it into the UTEC and then load it prior to starting the car?.Please enlighten me!


what mods?

injectors? turbo? cams?