i recently bought a subiegal pod with an autometer a&f gauge because i've always wanted and seemed to need one. question is, i've never installed a gauge before, just curious, how do i get the wires through ect... without them showing and what not, i'm for sure new at this gauge install thing. do i have to drill a hole through the dash or what? thank you very much for any answers.

Read this for more gauge information-
http://forums.nasioc.com/forums/showthread.php?t=1193843
You don't "need" that autometer A/F gauge, it provides nothing useful beyond some nice blinky-lights.

eh, it's not there, not what i was curious about. i've looked at that thread before, i just want to know how to get the wires through i know where to connect them, just how do i get them through, do i have to pull part of the dash off ect... the subiegal pod goes on the bottom left of the pillar in the corner there.

i put mine inside my glove box, and the wires went through the hole right infront of the glove box, and had to cut into the glove box, to get the plug thru. all in all, clean install. ill post pix later if you want.

i put mine inside my glove box, and the wires went through the hole right infront of the glove box, and had to cut into the glove box, to get the plug thru. all in all, clean install. ill post pix later if you want.


you CUT the glove box....it comes out with seven screws :lol:

you CUT the glove box....it comes out with seven screws :lol:

no, duh i know that, the back part, is closed off, not the actual glove box. i prolly should have stated that

edit: i should also say that i have the ngk rectangular one, not the circle gauge

hmm, i'm just curious where i would put the wires through if i'm placing the subiegal custom pod on the bottom left pillar in the corner there aka drivers side. if you search subiegal pod you will see.