How can I get a meth kit to be installed for 2 or 3 days, before I go get tuned for it, is that even possible?

dont supply power to it until your in the shop....i'm doing the same thing..

dont supply power to it until your in the shop....i'm doing the same thing..

ok, what percentage of meth to water are you running, and how are you gonna get the measurement right?

Install it all as you would normally but then just pull the fuse on the power supply to the kit...I personally like 50% meth/water mix

or what I do with cars that have remote map switching, I run a toggle switch to turn the meth on. :)

i have perrin meth and run 100% meth , kits can be installed easy in 1 day , depending on the kit.. smc snow are simple installs perrin and aqua mist are little more extensive but still within a day

If you were using our VC-25 controller it has an injection disable option. You pull one wire to ground and the controller is "on hold". As soon as the ground is released the controller is active. You could wire it up to a toggle switch on the dash for example. Then you don't have to mess around with pulling fuses or power wires.

Based on our tune you might want to look into an Injection Fail Safe. Our IFS-10 is a great option and only $139.00

http://www.labontemotorsports.com/store/ccp0-catshow/InjectionMonitoring.html

Best regards,

Dan