I have a slight problem.....Last night I was installing my BLITZ FATT DC IV and I came to the part where you have to cut and tape up the Dark Green with Black Stripe wire on the Keyless Entry Module.....Well, not paying much attention, I looked above the fuse panel and saw two harnesses, so I figured this must be it.....WRONG!!!!! I unplugged the harness, found the Dark Green with Black Stripe wire and cut it.....Then I noticed the small black box above.....which was the Keyless Entry Module.

Here's a pic of the Fuse & Relay Block to help with identification.
(the harness I am talking about is the one in the upper left hand corner)

http://img165.imageshack.us/img165/742/2002wrxfuseblockpz1.jpg

Now my question is this, what is the purpose of that Dark Green with Black Stripe wire that I cut??? What does it control/relay??? I'm not too familiar with the electric system and cannot properly identify it on a schematic. I quick fixed it by using a quick splice wire tap. But I need to know if I can just solder it back together with another piece wire (the same gauge of course) or if I have to replace the whole harness. PLEASE HELP!!!!!

Splicing in an extra piece of wire and soldering it well and then covering the bare wires with good electrical tape will work fine. It's just DC voltage you are dealing with.

wiring manual suggests it might go to fuse #18 (should be two green/blk wires) - goes to the AC relay, the sub fan relays, and the thermal protector. Hard to say much else (the pic you posted is really, really, really small...)

Later on today, I'll post a few pics of the Fuse & Relay Box. Thanks a lot.