k.. i have just install the S-afc for my 2.5 rs
and play aorund with it for awhile, got a pretty good setting now, BUT for some reason, i can't 100% start up my car. That was excepted. caz i dun knwo how to tune it. So i reset it to normal, like brand new, no setting is change. I still can't 100% start up my car. Sometimes it just go Shzzz Shzzz and then nothig happen. pump a little gas and start agin same thing. try again, it Works. but then i got those gasoline smell outside of the car. Howcome this is happening to me? any advice will help

Did you wire this correctly?

Mine works fine, and I haven't had a problem whatsoever.

What's your setting?
1) 4cylinder, Arrow up throttle
2) Pressure In 5 : Out 5

You used a soldering gun to connect the wires, right? If you just twisted and electrical taped the wires, SAFC and ECU may not function correctly. At least, that's what I read somewhere.

Check my site for more info: http://www.geocities.com/matsut_rpi00/safc.html

[This message has been edited by tmat3 (edited May 21, 2001).]

And what did you use to tune SAFC? Did you use A/F meter or EGT? If you don't have either gauge (preferably EGT), you may either lean out or richen too much, which may kill the engine.

oh i c..
i dun have those gauge. how much are those gauge actually cost.?
is this a INcrease prefermace setting ?
or just a normal setting which help nohing but just the look.?
1) 4cylinder, Arrow up throttle
2) Pressure In 5 : Out 5
i heard so many story about safc like different places will have different setting and so on.. i want a Unversal setting !
^-^ ..anyone can help?