Scoobymods only has the install on a GD A/B.

Has anyone documented the install on a GC8?

What parts do I need, where can I find them online, where on the engine do I tap?

Any help would be GREATLY appreciated.

I'm installing a 3 gauge pod on my drivers side A-pillar, is preperation for my turbo, and need to fill in an empty pod

:p

Cheers

Will

*bump*

Anyone?

If you're using a sandwich adapter, I bet the install will be straightforward without specific instructions for that model.
That assumes you have enough room "below" where the oil filter is now to accomodate the space of the adapter.

If the oil pressure switch uses the same threads and location as the 2002 WRX you can do what I did.

Check out:
http://www.pbase.com/daytontp/gauge_parts_stuff