Hey everyone, well back in August I had my car tuned and dynos at BM tranny with my AFC controller and I put down 288whp with my old exhaust and only 267lbs of torque.. Iv seen in this section of the forum that most people are putting down more torque or an equal amount of it....my question id, why didn't I? is it b. c the way the car was tuned???

mods:
Vishnu stage zero
m2 turboback(old exhaust)
turbboXs catless turboback(new setup)
vf30
sti injectors
walbro fuel pump
greddy fmic w/greddy intake
and engine mang apex SAFC

Are you running a UniChip and a S-AFC?

afc

might of been ur cat in the old exhaust.
definitely re dyno it with ur new exhaust.

also unichip might help w/ torque.

dunno, i almost have the exact same setup as you except im on stock pulley...it could do with air temperatures or anything. How much torque were you expecting? Those seem to be pretty good numbers depending on how much boost you were running

My Dyno (http://home1.gte.net/bcfox/dyno2.jpg)

i was at 16.5* lbs of boost...


-melo

Originally posted by krave
dunno, i almost have the exact same setup as you except im on stock pulley...it could do with air temperatures or anything. How much torque were you expecting? Those seem to be pretty good numbers depending on how much boost you were running

My Dyno (http://home1.gte.net/bcfox/dyno2.jpg)


krave... what kind of engine mgmt do you have. you have a VF30 also? NICE TUNE! you must have a FMIC too. (edit: i saw your post in another thread you have a unichip) is it a Turboxs or Vishnu?

Bob

Originally posted by westy66



krave... what kind of engine mgmt do you have. you have a VF30 also? NICE TUNE! you must have a FMIC too. (edit: i saw your post in another thread you have a unichip) is it a Turboxs or Vishnu?

Bob

I bought it used from someone who had vishnu stage 0, but had it retuned by cobbtuning