Hey whats up everyone. I've been trying to find a solution on how to get rid of the high beam indicator with HID's. I havent found a real solution so I thought I would make a official thread. So this is what I have found out..

Must disconnect the DRL connector in the engine bay

Must do fog light mod.

Also disconnected the DRL behind the glove box

Anything else?? My indicator is still on after doing those mods! Oh and I have HID's in my head lights and fogs. Add solutions! Thanks!

Jason

check the grounding?

don't know, however interested in this as well

That was my friends suggestion... We will be doing that this week but just wanted to see any other suggestions...

Jason

let me know how it turns out, may be I should do it too

Will do! Afterall, this is the official thread :)

Jason

How are your HIDs wired, particuarly the grounds? Are the ballast negatives connected to the factory switched grounds from the headlight plugs, or grounded directly to the chassis or battery? If you have them connected to the switched grounds that may be the problem, try directly grounding them.

You're talking about 9007 HID's in the stock reflector housings right?

-bd

Yes...

Jason

P.S. Will check ground later this week!

Jason