Hey made some good progress.

Question is can I use the power supply wires from the RS harness for the WRX harness.

Can I also use the grounds?

I also noticed that the Rear 02 sensor wire color: R/Y goes to the main relay. Can I connect it to the main relay on my RS?

I think I have a couple more Q's cant remember right now

Thanks guys

Andy

Yes to all those

I notcied yesterday while making the wires look neat I came across a wire that looked to be cut. I located the wire and is a Cranksensor shield wire. I never cut anywire near this so it was cut prior to me getting the harness. Its the yellow wire. I thought shielded wires were inside the gray tube not outside it? Im looking at the wiring diagram and it looks like the wire wraps around the gray tube that has 4 other crankshaft wires inside it. In my WRX manual its on page WI-73

Do you have any tips how I can fix this?

http://im1.shutterfly.com/procserv/47b4da38b3127ccebd724911002c0000001610

http://im1.shutterfly.com/procserv/47b4da38b3127ccebd72462a40880000001610

Now that Im looking at it maybe its supposed to be like that. Its not cut, and is still attached to the yellow wire.

For the VSS wire color: GB is goes to the WRX fuse box No. 18.

I don't know where to put this wire in my RS.

Its the 12volt supply for the speed sensor . You can tap that into the ignition "on" or another ignition power source.

thank you

OK here are some more.

On conenctor B134 Pin: 12 color: GR
I did not find this on my ECU pin out sheet or the actual engine electrical system pages? Anybody know what this is? I double checked too, to make sure it was the correct pin number?

Also

Connector B134 Pin: 2 . I'm confused it says Radiator fan relay 2 but it is also Purge control for the same wire? Can you help me out on this.

Thanks

Andy