Trizzle
07-22-2004, 04:46 PM
Is there a fix available to eliminate these OBD codes? I'm assuming that the reason for them is that the emissions plumbing has been removed during the turbo install the previous owner did on my car (Eric SS' old 2000 2.5RS). I've taken the turbo off and installed the original catalytic converter (which took care of those codes) but still am getting these codes.
What i'm hoping is available is some little resistor mod i can do similar to the MIL gadget used to eliminate CELs with aftermarket exhausts.
Here's the full code descriptions:
P0447 Evaporative emission control system vent control low input
P1443 Evaporative emission control system vent control function problem
I searched and found lots of reports of problems but the only solution i came across was to send the ecu to subaru for reprogramming. My car is long out of warranty so i don't want to do that (because i'm broke!).
What i'm hoping is available is some little resistor mod i can do similar to the MIL gadget used to eliminate CELs with aftermarket exhausts.
Here's the full code descriptions:
P0447 Evaporative emission control system vent control low input
P1443 Evaporative emission control system vent control function problem
I searched and found lots of reports of problems but the only solution i came across was to send the ecu to subaru for reprogramming. My car is long out of warranty so i don't want to do that (because i'm broke!).