Hello again,
Well I managed to screw something up here. Was hoping someone could help out with advice. So here goes. On Friday I installed an Omori Boost gauge in my car. Everything went as planned, I used the xtra radio harness behind the stereo to tap in my power and ground wires. When I checked everything out with the gauge before putting my dash back together it lit up fine and everything was good. Well I re-insert the stereo back into the dash and start the car up set all my stations and then go to play a cd. Now the damn cd player doesen't work anymore? But the stereo still works? I'm confused? So I was driving around yesterday and all the sudden the boost gauge light starts flickering and bam it's not lighting up anymore. The gauge still works and is reading the pressure and what not, but it won't light up? I checked the fuses and none were blown? I am totally at a loss here? The only thing I did behind the stereo was use the xtra harness? Didn't touch anything else. So does anybody know what the problem might be? Thanks for your help, yet again.

-D

Do you have an after market amp driving your speakers ?
Did you run the after market amp through the stock stereo
where did you wire the remote turn on for the amps
I ask all these because I ran into the same problem with my CD player it turns out the amps were not turning on when the CD player and tape player turned on but I could listen to FM and AM radio just fine if there sound like the problem you are having PM me and I will see if I can help you out. If I am totally off let me know

Sorry, I should be more clear. I have a totally stock stereo with no amps or aftermarket equipment. The boost gauge is the first mod I have performed on my car, and so far its not going so well.

Also the boost gauge is mechanical.