IA Performance has teamed up with eliteinternational and is proud to announce the official release of our KPH to MPH convertor systems. These are perfect for USA Subaru owners running JDM or EDM KPH clusters. No longer will you have to be handy with multiplying and dividing by 6 :lol: Works on 01-present 5 & 6 speeds (automatic guinea pig needed). Our kit form works on all electronic speedo heads except Nissan and Mazda. We offer the convertors in 2 forms:

Complete Form: (built in-house) $115 + ship

IA Performance incorporates (1) new Subaru factory harness with one of our convertors. The end result is a fully soldered weather proof plug and play harness. Total install time is roughly 20 seconds!!!
https://w109.webminders.com/iaperformance/specialsImages/small_100_2511.jpg

Kit Form: $75 + ship

You receive one convertor unit with wiring write up. Wiring and soldering is up to the end user.
https://w109.webminders.com/iaperformance/specialsImages/small_e0021.jpg

Both may be purchased on from our JDM catalog under Interior/Dressup and under Engine/Power/Exhaust. Simply click link below:

https://w109.webminders.com/iaperformance/catalog.asp?action=showCatalog&typeNumber=56&sectionNumber=67

More innovations to arrive this winter.

Stephen

www.IAPERFORMANCE.com

Subaru Audio Upgrades, Click the Subaru

http://www.iaperformance.com/images/iasignature.gif (http://www.iaperformance.com/)

2112 N Dragoon #16
Tucson, AZ 85745
520-882-2821
520-207-2494 fax
9am-6pm PST

Niiiiiiiiiiiiice

all 01+ cars or just subaru ?

The kit form actually works on all electronic speedo heads except for Nissan and Mazda.

The completed version is only plug and play with Subaru though.

Stephen
www.IAPERFORMANCE.com
Subaru Audio Upgrades, Click the Subaru
http://www.iaperformance.com/images/iasignature.gif (http://www.iaperformance.com)
2112 N Dragoon #16
Tucson, AZ 85745
520-882-2821
520-207-2494 fax
9am-6pm PST

Do you have directions for installation online? I'd like to see what's involved before deciding which one to get. Does the connector with wire you sell basically go from the cluster to somewhere behind the dash? Thank you.

Oh, and this won't work in a MY00? I have a Ver. 4 tranny and a Ver. 6 cluster, what decides if it will work? Thank you.

The instructions included with the "kit form" unit are a little vague. We've seen a few methods used at wiring in the elite units, some directly to the back of the gauge cluster, some at the tranny extension wire, etc. The included paper form with the "kit form" will state something to the tune of (paper is not in front of me currently):

Convertor Stock WRX Loom Colors
Black Brown/Ground
Red White/Power
Gray Green headed towards ecu/ Signal
Yellow Green headed towards tranny/ Signal

HOpe this helps, MY00 w/ ver6 cluster should not be an issue. Would you happen to know if your tranny has a wire similar to the one white one posted above (should be found on the right side of the tranny).

Stephen
www.IAPERFORMANCE.com
Subaru Audio Upgrades, Click the Subaru
http://www.iaperformance.com/images/iasignature.gif (http://www.iaperformance.com)
2112 N Dragoon #16
Tucson, AZ 85745
520-882-2821
520-207-2494 fax
9am-6pm PST