Just got the Defi gauges and control unit in the mail. Before I go diving into putting these in I was wondering if I could see where everyone else is tapping in for the power, ignition, illumination, and ground wires. Pictures would be helpful too Thanks!

I tapped into the clock. It has all of the necessary wires. I extended all of the controller wiring so that I could put the controller into the center console too.

tapped into the clock wiring for my set up . just get a light tester or something similar and find out the wiring . used the same theory to run my tein edfc . hope this helps . all most forgot but if you got the defi center make sure that once you put that thing in you don't take it out . i broke 1 of the tabs when i took that thing out to do some rewiring . :D

If you'd like the Defi gauge lighting to dim with the factory gauges, you might want to check out this (http://www.scoobymods.com/forums/showthread.php?threadid=3115) link. Works perfectly with my v1 controller.

Brent.