a buddy of mine bought a JDM intake manifold he said it was a ver8 but i am not for sure can you all help me out a identify this intake mainfold i dont have a pic but this thing has the longrunners( no TGV's) so i thought it was a ver8 but it also has a opening right were the stock BPV would bolt up to the I/C ti has a small 1-2 inch circler opening this is what puzzles me i have no idea what this thing is but i know it has the red paint and no TGV its has everything fule rails stock turbo inlet top feed rails everything you would need.
help me out Dustin

Dont know what you have how does it compair to this pic?


http://forums.nasioc.com/forums/showthread.php?t=627573

I can't even read that.

Dont know what you have how does it compair to this pic?


http://forums.nasioc.com/forums/showthread.php?t=627573


thats USDM you can tell bye the spacer were the TB bolts up and the runners are shorter.

i know my grammer is not all that good ;) but help me out the 2 in opening is not the TB opening its right next to that right were the stock BPV would go almost looks like the recirclation would go right there but that cant be it... i have a pic if some one will host it for me.

thats USDM you can tell bye the spacer were the TB bolts up and the runners are shorter.



Actually I disagree, the mani where the TB bolts to is not clearenced for the DBW. It is a JDM piece but must be a V7 or earlier

Pm sent

OK how about this one:

http://www.iaperformance.com/specialsImages/full_Copy%20of%20DCP_4271.JPG

Does yours have the bolts that the throttle cable bracket bolts to?

e mail sent

thanks for helpin me out

some say mabey ver5 or 6
but i am at a loss
Dustin

This Is a pic of a JDM ver 8 manifold in the front, with a USDM SIi manifold in the back. I have installed a ver 8 on my USDM STi and I am with pestysti the pic of the manifold looks like a USDM STi because of the spacer for the drive by wire throttle body, and the nipple that is under where the trottlebody bolts on, the JDM manifolds come with a check valve there, the USDM manifolds just have a vacuum nipple there and put the check valve closer to the block.

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wNTk2Njg4NnM0MTNkZmQzMXk1NDE%3D.jpg

in the pics i sent to Biker boy the inj. are side feed but the mainfold has the long runners of the ver. 8 along with that weird hole were the factory BPV would go on the IC. as soon as he post the pics for me i think you all will be able to help me out.


some say its a ver 5-6 before the TGV were put into use and before the topfeed inj.
i am intrested in finding out what this peice is...... my buddy bought it from a guy in Tokyo under the impression that it was a ver.8 but the pics will tell the tale.
Dusitn

I got Dustins pics this morning. What he has is definiately not a V7 or 8 manifold. It has the mounting bosses for the coil pack on the plentum. My vote is V5 or earlier.

BB