Will be having my car tuned next week by clark at king pin!!.
Any one what to guess what kind of hp i will make on 26psi's @ c16 with my turbo :confused:
Mods

04 STI
APS DR500 FMIC
Garrett t3/t04e hybrid turbo housing 3" inlet 2" outlet
'stage 5 t350 turbine wheel .50 trim compressor wheel,Turbine Housing A/R Ratio.63 "
Turbonetics evo.wastegate
Custom Up-pipe
APS 3.5 Turbo-Back Exhaust
APS Cold Air Intake
APS BOV High volume twin vent
APS WRX Tumbler-Delete Valve's
APS WRX Race Fuel System
Walbro 255Lph Fuel Pump
MZM 720cc top feed injectors
SX Fuel Pressure Reg.
Borla Header
Iridium Power plugs
GFB pulley set
GReddy Profec B spec II
Utec
spec stage 3 clutch
Darton Iron Sleeves
CP forged Pistons with rings
Pauter 4340 connet. rods
ARP Head Studs
Cometic Head gaskets
port and polish heads
Axis titanium Retainers

With 2 FMICs, you should have no problem

Will be having my car tuned next week by clark at king pin!!.
Any one what to guess what kind of hp i will make on 26psi's @ c16 with my turbo :confused:
Mods
04 STI
APS DR500 FMIC
04 STI
APS DR500 FMIC
Garrett t3/t04e hybrid turbo housing 3" inlet 2" outlet
'stage 5 t350 turbine wheel .50 trim compressor wheel,Turbine Housing A/R Ratio.63 "
Turbonetics evo.wastegate
Custom Up-pipe
APS 3.5 Turbo-Back Exhaust
APS Cold Air Intake
APS BOV High volume twin vent
APS WRX Tumbler-Delete Valve's
APS WRX Race Fuel System
Walbro 255Lph Fuel Pump
MZM 720cc top feed injectors
SX Fuel Pressure Reg.
Borla Header
Iridium Power plugs
GFB pulley set
GReddy Profec B spec II
Utec
spec stage 3 clutch
Darton Iron Sleeves
CP forged Pistons with rings
Pauter 4340 connet. rods
ARP Head Studs
Cometic Head gaskets
port and polish heads
Axis titanium Retainers

The answer you are looking for is "yes" - but, depending on the dyno, that's going to max that compressor and FMIC/intake. That power level should be very obtainable.

-Sean

i would say for sure after seeing a stock block sti on pump gas do a little over 400whp.

We shall see.... But that .63 Turbine is on the small side for that size motor. Should be fun though.

C