|
View Full Version : Access Port Stuck In Stage 2 gsteclipse33 01-08-2005, 01:33 AM well i was trying to flash the stock map so i could bring it to the dealer and i set it up to flash and then when i check whats map its on it says stage 2 93 oct again do i need to put those connectors on to flash stock map thats the only thing i havent tried jdubman 01-08-2005, 02:34 AM yup.....exactamundo! drees 01-08-2005, 03:28 AM Yes, sounds like you only switched the real-time map. Should be good enough, but you may want to reflash the base map by hooking up the connectors under the dash and reflashing the base map. scrapin' 01-08-2005, 01:12 PM Your only going to see your base map...the AP won't show you your reltime map....so if you flashed the reltime "stock" map, you'll still see "stage 2 93 octane" when you go to check your map. fasterthanrayswrx 01-08-2005, 01:27 PM Your only going to see your base map...the AP won't show you your reltime map....so if you flashed the reltime "stock" map, you'll still see "stage 2 93 octane" when you go to check your map. exactly gsteclipse33 01-09-2005, 02:41 AM o ok cool thanks alot Brahmzy 01-09-2005, 02:54 PM Do you have a big hammer? Killian Maynard 01-09-2005, 11:48 PM Shouldnt you switch the base map to stock as well (uninstall AP)? If the dealer decided to do some work they will invariably disconnect the battery. Once the battery is disconnected the ECU will revert back to the base map. In your case if you left the base map at stage 2 the dealer could effectively notice the stage 2 programming. Also arent you worried about having a DP while taking your car to a dealer? gsteclipse33 01-10-2005, 02:19 AM thats easy to change out i didnt say i dont take it out Killian Maynard 01-10-2005, 02:37 AM thats easy to change out i didnt say i dont take it out So do you run the stock map (base map, AP uninstall) when you take it in as well? gsteclipse33 01-11-2005, 03:14 AM nah just stock real time thye dont see m to kno |