First off, I need to know where the 3 lines on the intake elbow go to and the rest of the PCV setup.

2. The big sensor on the driver side of the intake manifold, there is a hose that comes out of the bottom. Where does that go?

3. The bottom of the header tank for the coolant, where does that nipple go to?

4. Where do these 4 hose connections go to?
http://img308.imageshack.us/img308/1882/pict25806wm.jpg

This is what happens when you buy a car that is completely torn apart. Oh well. Thanks!

Brent

#1 hmm 3 lines, well one goes the the BOV, another goes to the pcv system: it connects the two heads, block vent and pcv valve, Im not sure about the thrid but this should help http://www.graphics.cornell.edu/~v/vacuum/ej22t_pcv.gif

#2 Thats your Idle Air Control Valve (IAC) the hose needs to be plumbed in anywhere between the Mass Air Flow Sensor and the turbo.

#3 I dont remember

#4 this should help http://www.graphics.cornell.edu/~v/vacuum/ej22t_vacuum.png
this is for a USDM legacy but it is very similar

#1

http://home.comcast.net/~r.files/WRX/intake_elbow.jpg

-Rob

#2

It connects to a hard line under the manifold. I think that is the same hard line that pops up by the intake elbow and connects to the intake resonator box.

http://home.comcast.net/~r.files/WRX/iac.jpg

#3, kind of a crummy picture, but it is a pipe on the radiator itself

http://home.comcast.net/~r.files/WRX/header_tank.jpg

Wow! Both of you, thanks! That should help me out a lot. I'll search around a little bit for where that coolant line goes. It's that bottom one coming out and then going behind the power steering resevoir.