Hope it's ok to repost this from the classifieds. You guys are alot closer so...

Vehicle was rolled, most of the body panels are in bad shape. Interior is good just dirty. Engine has close to 100,000 mi, was running good, had new parts installed a week before. I haven't tried starting it yet, two of the plugs were covered in oil, and the air filter. I have a '95 1.8 that can use some parts, plus I'm looking for a 2.5rs which may share some parts.

If anyone is interested in anything, I can check the condition.
In the valley by the way.

http://i3.photobucket.com/albums/y61/pacificblue_200sx/Passside.jpg

http://i3.photobucket.com/albums/y61/pacificblue_200sx/Driverside.jpg

http://i3.photobucket.com/albums/y61/pacificblue_200sx/Interior.jpg

http://i3.photobucket.com/albums/y61/pacificblue_200sx/Engine1.jpg

i might be interested in the radiator if it's ok. also would like to check out the r/h mirror.

Jerry

I definitely need the radiator ASAP if Jerry doesn't take it. My car's dead without it. I could use the fan and shroud, too.

Are the headlights or corners good? Got a pic from the front? I could use a few odd and end interior pieces, too.

Maybe you should post what you're going to use so we have a better idea of what's available.

Here's the link to your other post...

http://forums.nasioc.com/forums/showthread.php?t=887276

Looks like alot of interior stuff is going to have dibs. I'd becareful of how you run the two posts. You don't want to run into any conflicts.

Winslow

i might be interested in the radiator if it's ok. also would like to check out the r/h mirror.

Jerry

The radiator is almost brand new, was put in a week before the accident. No joke. But look at the right side bracket, I believe it broke off the mounting point on the radiator. I'll verify when I get home. It's still seems solid though.

Well I'm stupid I guess, do you mean passenger side mirror?
They are both fine, but the drivers side one about came off, should still work.

I definitely need the radiator ASAP if Jerry doesn't take it. My car's dead without it. I could use the fan and shroud, too.
Same as above.

Are the headlights or corners good? Got a pic from the front? I could use a few odd and end interior pieces, too.
Passenger side headlight busted, other is ok. I think the corners are ok, can't remember. I'll take a picture from the front later today. Let me know what interior pieces you'd be interested in.

Maybe you should post what you're going to use so we have a better idea of what's available.

Here's the link to your other post. Looks like alot of interior stuff is going to have dibs. I'd becareful of how you run the two posts. You don't want to run into any conflicts.

Winslow

Good points, I'll keep an eye on that, thanks.
So far, I've only taken the starter/alternator belt/rearview mirror. I had planned on parting out everything I can, and use whatever's left myself.

I'd also be interested in the following...

tranny
tranny crossmember
maybe the transmission driveline
clutch & pressure plate
flywheel
pilot & throw out bearing
shifter, linkage, and rear shifter support bushing
clutch/brake pedal assembly
clutch cable
clutch master cylinder, slave cylinder, and hoses
starter
maybe the ECU
cam cover

When can we get the parts? I need some of these ASAP.

Winslow

seatbelts? lemme know

i don't need the radiator, not sure if it'd even fit my application. but i would like to look at the good mirror and see if it could be used to repair my forester mirror.

jerry

Thanks Dog!!!

ak_impreza, do you have a phone number?

Winslow

damn! if only you were not in Alaska! I would have taken the Dash, consoles, and all the plastic in the interior. Bump for you!

I definitely need the radiator ASAP if Jerry doesn't take it. My car's dead without it. I could use the fan and shroud, too.

Are the headlights or corners good? Got a pic from the front? I could use a few odd and end interior pieces, too.
This couldn't have come at a better time, eh? FWIW, that radiator won't work for you until you swap the tranny out, as it doesn't have the transmission cooler in it for the automatic trans.

AFAIK, I'm pretty sure both AT/MT use the same radiator. I should say one uses the nipples and the other doesn't. We'll have to see what he has. I'd swap the tranny just to get the car running.

I figure I could use it either way.

Winslow

yeah even if it doesn't have the cooler, just add an aftermarket one, or i have an old a/c evaporator that looks like it might work haha.

I'd also be interested in the following...

tranny
tranny crossmember
maybe the transmission driveline
clutch & pressure plate
flywheel
pilot & throw out bearing
shifter, linkage, and rear shifter support bushing
clutch/brake pedal assembly
clutch cable
clutch master cylinder, slave cylinder, and hoses
starter
maybe the ECU
cam cover

When can we get the parts? I need some of these ASAP.

Winslow

Make me some offers, I'd obviously prefer to sell to you guys, don't have to deal with shipping. My wrenching skills are less than stellar, so I'd just have to figure out how to remove stuff, shouldn't be to hard. I'd be willing to meet someone halfway if they'd like. Maybe Eagle River, I'm in Wasilla by the way.

seatbelts? lemme know

All of them?
How about $35?

Thanks Dog!!!

ak_impreza, do you have a phone number?

Winslow

357-4158 please only call between 5pm-10pm, I work nights.

The one mounting point for the radiator did break off, so if anyone still wants it, it I'd sell it cheap. It's pretty much new.

Edit pic:
http://i3.photobucket.com/albums/y61/pacificblue_200sx/Radiator.jpg

I'm still interested in the radiator. I'll be calling you. Also, I'm in Eagle River.

Winslow

i don't need the radiator, not sure if it'd even fit my application. but i would like to look at the good mirror and see if it could be used to repair my forester mirror.

jerry

I can take a pic, or you can come see it if you want.

Is the grill intact?

Winslow

Is the grill intact?

Winslow

Yeah I just took it off, it's good.

I'll take that, too.

I see someone paid for the shift boot but I mentioned here that I wanted the shifter. I assumed that the shifter included the boot and knob?

Winslow

I'd also be interested in the following...

tranny
tranny crossmember
maybe the transmission driveline
clutch & pressure plate
flywheel
pilot & throw out bearing
shifter, linkage, and rear shifter support bushing
clutch/brake pedal assembly
clutch cable
clutch master cylinder, slave cylinder, and hoses
starter
maybe the ECU
cam cover

When can we get the parts? I need some of these ASAP.

Winslow

I'll take that, too.

I see someone paid for the shift boot but I mentioned here that I wanted the shifter. I assumed that the shifter included the boot and knob?

Winslow

Ok, you get the grille too.
Sorry but I didn't know you wanted the boot & knob also. I have the knob still though.
I'll be home most of the day, so just give me a call. If I'm not home my cell is 841-3839.

Bobby

I know I'm in florida and the most bpdy pieces are :(, but how's the trunk lid by chance?

I know I'm in florida and the most bpdy pieces are :(, but how's the trunk lid by chance?

The trunk is good actually, one tiny dent that can hardly be seen.
Yeah I'm really not sure about shipping it that far though, I'd be willing to check UPS ground rates. If you give me an idea of what you were wanting to spend, I could see if it's even feasible.

Thanks,