has any one done this to an 03> WRX or STI?

if so have you got any instructions i can follow for it? as the injector seems too fat for the hole yet its come with spacers and screw etc....

can anyone help?

The injector is too fat by itself, too fat with the stock o-rings, or too fat with the supplied o-rings (if there were any)?

http://www.sox-main.co.uk/Neil/injectors.jpg

this is it compared to a PE800, its the physical width of the injector yet its supposed to be generic?

any hints? :)

Thanks....

bttt anyone?

It does not look like the correct injector for our manifold.

Is that a 1000cc/min RC?

I have the same injectors, though I'm not sure they look like that at the nozzle end.

S.

i'm currently using the RC750's and they fit, they just took a little pressure to get in there. make sure you lube up the o-rings to prevent tearing on installation and for a good seal. the spacers are a pain in the ass since you have to slightly relocate the fuel rail and make sure it bolts down straight. if i hadn't already bought them, i woulda gone with modded stocks (nice free mod with a little cost if you want to have em flow tested) or with the PE's.