View Single Post
Old 07-03-2005, 07:30 PM   #4
Caboobaroo
Scooby Specialist
 
Member#: 72335
Join Date: Oct 2004
Chapter/Region: NWIC
Location: Oregon City, OR
Vehicle:
89's RX/XT6
Blacksssssss

Default

I picked up an '89 RX back in November. Still working on getting it running but I have a list of mods a mile long right now that I have been doing since I pulled the old motor out. Here's a few things I have been working on:
'02 WRX TD04 turbo
'02 WRX TMIC
Samco intercooler hose set (y-pipe, IC to TB, and recirc hose for stock BOV)
TurboXS BOV
modified stock header until I can get a TWE
WRX downpipe
custom cold air intake
Greddy Profec II B-spec EBC and Auto Turbo Timer
5-lug conversion with WRX front struts and brakes
WRX 3 gauge A-pillar pod
aftermarket steering wheel and shift knob
automatic to manual transmission conversion
stage 2 clutch kit
dual electric fan setup

The engine however is all stock. I do have another engine that will be getting built as soon as I get her running with this one. A short list of the new motor includes:
full rebuild with carbed pistons
spider intake manifold
300ZX turbo injectors
Delta 260 street cams
new pumps (oil and water)
rebuild heads with 3 angle valve grinds, port-n-polish, portmatching
lightened flywheel and custom crank pulley with EDIS ring attached
full MegaSquirt and EDIS setup
custom equal length fuel lines
higher volume fuel pump
well you get the idea
* Registered users of the site do not see these ads.
Caboobaroo is offline   Reply With Quote