View Single Post
Old 07-20-2005, 09:33 PM   #40
wgknestrick
Scooby Specialist
 
Member#: 32576
Join Date: Feb 2003
Location: Allentown, PA
Vehicle:
04 STI
Roller Barrel ITBS

Default

I am having problems with leaks right now. I still have one intake leak with it leaking at the MAF sensor and multiple exaust leaks due to poor fitment of the Godspeed kit.

So far I have been having problems with most of the Godspeed Spec 650R pieces. The MAF hole is about .010" smaller than stock which causes the O-ring to bind up and not seal. And the EWG pipe fitment is poor causing a leak at the V-band flange because it is not square. Dan claimed that blow thru was the answer, but I cannot get the car to even idle with the MAF sensor plugged in on the stock ECU. I also have a ODB2 inspection in Dec! I am truely screwed. I will try to sort this out when I get back from vacation next week, but I am having problems.

At least it looks nice.....
* Registered users of the site do not see these ads.
wgknestrick is offline   Reply With Quote