View Single Post
Old 07-25-2005, 03:55 PM   #12
8Complex

Moderator
 
Member#: 922
Join Date: Feb 2000
Chapter/Region: MWSOC
Location: Schaumburg, IL
Vehicle:
04 FXT
Red

Default

With a standalone, you're supposed to install the IAT in the manifold, or just before the TB. Otherwise you're going to be kicking yourself in the nuts trying to get it tuned right. Depending on the weather (wind, etc), your temperature after the intercooler could be a lot different from run to run with the same inlet temperatures.

The equation for fueling in a MAP-based setup is strictly IAT/CTS/MAP based as to what is going into the engine (other than the CTS, obviously).
* Registered users of the site do not see these ads.
8Complex is offline   Reply With Quote