NASIOC - View Single Post - Could methanol or water injection be a replacement for sleeving a 2.5ltr block?

tino · 08-02-2005, 08:45 AM

Could methanol or water injection be a replacement for sleeving a 2.5ltr block?

Im wondering that ovaling of the standard EJ25 liners may be due to increased heat generated when pumping out heaps of power. Would keeping those conditions cooler i.e by water injection prevent fatigue on the liners at power levels over 400-500hp atw on pump

Please discuss

* Registered users of the site do not see these ads.

08-02-2005, 08:45 AM	#1
tino Top Scoob 019 Member#: 43630 Join Date: Sep 2003 Location: Down Under Vehicle: 2004 GT40R-built 2.5 604 whp @1.8 BAR on VP109	Could methanol or water injection be a replacement for sleeving a 2.5ltr block? Could methanol or water injection be a replacement for sleeving a 2.5ltr block? Im wondering that ovaling of the standard EJ25 liners may be due to increased heat generated when pumping out heaps of power. Would keeping those conditions cooler i.e by water injection prevent fatigue on the liners at power levels over 400-500hp atw on pump Please discuss * Registered users of the site do not see these ads.