View Single Post
Old 08-17-2005, 02:11 AM   #43
STI4ME
Scooby Specialist
 
Member#: 6034
Join Date: Apr 2001
Chapter/Region: BAIC
Location: Fresno, CA
Vehicle:
2002 WRX
It's Soo-BAH-roo

Default

Guru

I'm in the midst of doing my bearings. Just a few observations:

1. unless I'm looking at the pictures wrong, under step 6 & 7 (assembly and disassembly of hubs), the pictures seem to be a little out of sequence/reversed. Look at step 6. Pressing the bearing outside in, but second picture shows pressing it inside out. Instructions are correct tho.

2. Might want to mention removal and installation of snap rings. BTW, the factory manual does not say to replace the snap rings. I removed mine and they look ok.
* Registered users of the site do not see these ads.
STI4ME is offline   Reply With Quote