View Single Post
Old 11-09-2005, 12:42 PM   #67
IA Performance
NASIOC Vendor
 
Member#: 25194
Join Date: Sep 2002
Chapter/Region: RMIC
Location: Boulder, CO
Vehicle:
2008 Forester XT 5mt
Dark Gray

Default

These are for:

2002 JDM HID Sti factory ballasts
Wiring into 2002 US wrx

Would the ground be the Large Black/Small Orange combo, or the Large Blue/Small Brown combo? The Large gauge black wire used to be a part of the bulkhead harness. the Small Orange wire on the other end goes to the ballast.

I've already done quite a bit of searching and reading, but no one seems to mention which wire is the ground on a real JDM HID ballast.



The other side looks like this w/ the Ballast:


Logic would say assume the large black wires are the grounds and assume the large blue and large red are the power wires. But with expensive ballasts assumptions are never good

This thread was of good use as well:
http://forums.nasioc.com/forums/show...t=Daniel+Stern

Thanks in advance
SC
* Registered users of the site do not see these ads.
IA Performance is offline   Reply With Quote