View Single Post
Old 01-16-2006, 09:47 PM   #1
snowman4us
Scooby Specialist
 
Member#: 21764
Join Date: Jul 2002
Chapter/Region: RMIC
Location: Salty Lake
Vehicle:
Some GDM V8,
JDM Flat 4 X2

Default EJ20H wiring diagrams. please help

So im in a bind at this point.
Im about to do an EJ20G swap into my GF8. when i bought the engine the harness was so torn up that i had to get a new one. After 2 months of searching for an EJ20G harness with no sucess i ended up buying a EJ20H harness, sense the engines are extreamly similar i figgured i could use the H harness to run the G engine.
Looking closer at the harness i noticed some major diff. between the G and the H harness. So what im going to have to do is take out the old EJ20G engine harness and replace it with the EJ20H. also the wiring harness is a bit diff. also. the colores are diff. and the guages of wires are diff as well.
so this is what im looking for...

EJ20H wiring diagrams from a subaru manual

i know i have posted this up before, but now im just stuck between a rock and a hard place, i found some EJ20H diagrams, but they where hand written/typed and i dont trust the accuracy of them. my engine is ready to go in, and i got everything i need to do the swap. so now im just trying to get the wiring done and ill be boosting.
if someone has these i would greatly apretiate it.

thanks
kirill
* Registered users of the site do not see these ads.
snowman4us is offline   Reply With Quote