View Single Post
Old 02-13-2006, 03:02 PM   #13
n2xlr8n
Scooby Specialist
 
Member#: 18960
Join Date: May 2002
Chapter/Region: South East
Location: Bama
Vehicle:
02 WRX MBP
It lives! ; )

Default

Seriously.....If I were to do it (and I have no doubt that I could)...I'd start with finding out if a aftermarket front subframe / suspension could be "re-engineered" into the Subaru. Keep in mind, you may have to remove the tranny tunnel anyway, to get the geometry straightened out....and I'd bet the rear suspension would be a bear, too....not enough room for a 9 inch or 12 bolt with the conventional 4 link or coil-over / ladder bar setup.

I'd get out the DOM tubing / aluminum and get to work. It would probably be cheaper, and less headache.


S.
* Registered users of the site do not see these ads.
n2xlr8n is offline   Reply With Quote