View Single Post
Old 03-06-2006, 08:09 PM   #16
Ultimate Collision Center
Vendor
 
Member#: 69072
Join Date: Aug 2004
Chapter/Region: Tri-State
Location: Peekskill
Default

Quote:
Originally Posted by El Supremo
tribalwrx, RaiN, aprazma and whomever at ULTIMATE CC

A little bit off the subject since I don't have my kit yet. At what PSI (boost level) did you set your Alky/Meth/Water system to kick-in, (4psi, 5psi, 6psi???) cut-out? What the lowest PSI level (on-set of boost I hope) can you set the system? I don't mind using more Alky/Meth/Water mixture to get an early low-end kick in the pants.

My birthday's March 11th and this is going to be me and my wife's birthday present to me. Want ta fall off the wagon something fierce.
The rule of thumb for onset boost in most cases is about a 1/3 of your max boost, I run it on my evo so I have it turn on at 9lbs. It doesn't have to be exact but its a good place to start and you (or your tuner) can adjust from there.
* Registered users of the site do not see these ads.
Ultimate Collision Center is offline   Reply With Quote