View Single Post
Old 03-21-2006, 06:48 PM   #4
txl146
Scooby Guru
 
Member#: 32459
Join Date: Feb 2003
Chapter/Region: Tri-State
Location: NY
Vehicle:
02 WRX VF34
Junior Tuned 301whp

Default

Now, it's time to put a new turbo back on. Most important thing is to put your hand as shown below and hold turbo return hose (shown above) with your left hand. While you are holding it with your left hand, using your right hand, gently sit the oil return hard pipe and push it down. Once it's completely down, use a squeeze clip to secure it. This may be the hardest part during the turbo install. Since my hand is relatively small, I didn't have much trouble. At the same time, turbo inlet hose should be connected to the turbo inlet.

* Registered users of the site do not see these ads.

Last edited by txl146; 03-21-2006 at 11:14 PM.
txl146 is offline   Reply With Quote