View Single Post
Old 04-06-2006, 10:31 PM   #1
legacydreamz
Scooby Specialist
 
Member#: 92423
Join Date: Jul 2005
Chapter/Region: Tri-State
Location: locked in the freezer
Vehicle:
2007 Honda CRV
still locked in freezer

Default engine trouble, help

ok, i have a 95 legacy l. i just did the headgaskets and now the car wont start. before i did the headgaskets, then compression was all 180's except one cylinder.

now, the car will not start- it will turn over but will not start. i checked compression again. cyl 1 & 3 are now 120's and 2&4 are 180s. this is so agrevating!

anyone have any ideas? i know im getting spark and fuel. maybe i did the timing belt wrong? the haynes manual said the indents on the cam gears were to line up with the notch on the top of the rear cam covers. and the crank was to line up the arrow with the notch by the crank angle sensor. is this right?
* Registered users of the site do not see these ads.
legacydreamz is offline   Reply With Quote