View Single Post
Old 06-17-2006, 02:15 PM   #103
TheMadScientist
Scooby Guru
 
Member#: 23717
Join Date: Aug 2002
Chapter/Region: NESIC
Location: Beverly, MA
Vehicle:
2005 Big red

Default

Quote:
Originally Posted by TommyWRX
So how do you wire this in? I mean power and ground for the solenoid? And Will how do I control it with Utec?
You read this thred it tells you how to do everything.

Quote:
Originally Posted by FromageTheDog
A 3-port will operate in bleed (2-port) mode if hooked up that way, at which point it should act just like a stock BCS. Just put a filter over the unused port for safety.
The gm solenoid comes with a filter on it.

TMS
* Registered users of the site do not see these ads.
TheMadScientist is offline   Reply With Quote