View Single Post
Old 07-27-2006, 03:51 PM   #12
x99percent
Scooby Specialist
 
Member#: 27108
Join Date: Oct 2002
Chapter/Region: MWSOC
Location: Detroit-ish, MI
Vehicle:
2004 STi
2004 A4

Default

Quote:
Originally Posted by SloRice
ok, next question. Do you know if the ECUtek program will allow me to go into the STI ECU and recalibrate the MAP sensor voltages?

i.e. stock MAP sensor - 5V=~22psi. I need to recalibrate it so that 5V = 4.5bar
Hmm... a direct answer to your question is "I'm not sure". I don't see any MAP scale table in anything I've got.

An indirect answer is that it doesn't matter. The MAP sensor signal to the ECU is capped by your UTEC to whatever voltage corresponds to 12psi on a stock MAP sensor, plus the factory ECU doesn't use MAP for anything except for boost control (which you're not using) and a brief moment after a (cold?) start.
* Registered users of the site do not see these ads.
x99percent is offline   Reply With Quote