View Single Post
Old 07-29-2006, 11:25 PM   #1
ninjaboy76
Scooby Newbie
 
Member#: 33456
Join Date: Feb 2003
Location: Wichita, KS
Vehicle:
2015 WRX
WRBP

Default Water injector nozzle install with FMIC Question

I searched and couldn't find anything, but I was wonder how people were installing the injector nozzles with a FMIC. I just finished up my SMC kit and mounted my injector just before the bypass valve hose. I hope this will work. I wanted to mount it closer, but it wouldn't have been possible because my lower FMIC hose coming off of the turbo is to close to the upper hose connecting to the TB. So there isn't any room to mount the injector nozzle any closer than just after bend in the upper hose, but right before the bypass valve hose. Do any of you guys see and issue with this? I was concerned about the alky going into the bypass valve tract inbetween shifts.
* Registered users of the site do not see these ads.

Last edited by ninjaboy76; 07-30-2006 at 12:35 AM.
ninjaboy76 is offline   Reply With Quote