View Single Post
Old 08-06-2006, 04:50 PM   #4
NewSTI
Scooby Specialist
 
Member#: 104420
Join Date: Jan 2006
Chapter/Region: SCIC
Location: Orange
Vehicle:
05 GarageTuningSTI
BLK/Gold [email protected]

Default

Quote:
Originally Posted by desert pirate
I would like to look at dyno graphs of stock subarus 2L, 2.5L whatever vs. thier upgraded turbo setup on the same graph so I can compare low end torque. So If you have a graph with a stock and modified turbo plotted together I would like to see it.
Thanks
I have never see any turbo on STI makes "GOOD" tq under 3000 rpm, i remeber there was a guy with 20g with about 200wtq at 3000rpm..however, my stage 2 made 370 flywheel tq at 3000 rpm and stock turbo.

I am not sure if i'm correct, but boost lvl is where u get tq from, so low end tq needs to = early boost , which means smaller turbo is easier to do so...or high compression..

this is stock turbo with stage 2 after ecutek
* Registered users of the site do not see these ads.
NewSTI is offline   Reply With Quote