Thread: Head Bolts
View Single Post
Old 08-24-2006, 01:00 PM   #15
Tim Sanderson
Scooby Guru
 
Member#: 6486
Join Date: May 2001
Chapter/Region: MWSOC
Location: S.E. wisconsin
Vehicle:
00 Impreza 2.5 RS
Blue Ridge Pearl

Default

oil pump bolt torqueing sequence and torque spec for ej motors

no sequence listed I just start at the top and skip two going clockwise

Useing a liquid gasket make a thin bead around the outside of the pump staying inside of the bolt holes and outside of the o-ring hole.

Looking at the back of the pump. run a bead from the left side alignment dowel hole diagonally downward to the right along that ridge and down to meet your existing bead.

put a small dab of sealant on the new oil pump seal and affix it onto the recess in the block after you wipe the oil out of there.

Torque spec is 5 ft lbs. go around twice to be sure.
* Registered users of the site do not see these ads.
Tim Sanderson is offline   Reply With Quote