View Single Post
Old 09-07-2006, 10:52 PM   #3
Chp_Stix
Scooby Specialist
 
Member#: 95195
Join Date: Sep 2005
Chapter/Region: W. Canada
Location: Under the hood, in the seat!
Vehicle:
1974 Rat Rod Bug
back and white

Default

Step Two:
Tools:
Flat head screwdriver
Phillips screwdriver

Pull out the headlight, cannot make it anymore simple. Just pull and work on it, it will come out. TIP: it will be easier if you remove the bulb cover for you LOW BEAM i.e. Round cover on back of headlamp.

Yea! You have now removed your headlamps, time to become Betty Crocker!!

Pre-Heat oven too 200*F, get a cookie sheet and cover it with a towel, take all the bulbs out of your head lamp and remove the 5 screws in the back of head lamp.

Bake your headlamp for 15 Ė 20 min. make sure the lamp is not touching any metal inside the oven you have been warned.

Remove the lamp, donít worry it isnít too hot use oven mitts if you like I just grab it with my hands and start pulling it apart, use the flat head screw driver to pry it a bit and loosen it up. Soon it will come apart a bit and then continue to pull until it becomes two pieces.

End result should look like so:

Step 3 ish
* Registered users of the site do not see these ads.
Chp_Stix is offline   Reply With Quote