View Single Post
Old 10-03-2006, 09:46 AM   #1151
WRX-ERROR
Scooby Specialist
 
Member#: 83211
Join Date: Mar 2005
Chapter/Region: Tri-State
Location: Wilkes Barre, Pa
Vehicle:
2002 WRX - stg4
PSM

Default

Quote:
Originally Posted by Matth3w View Post
I was wondering if the OP can update this trick in the first post since it seems to be a bit of a frequently asked question (and as of page 8 I havent seen a really good answer):

When you are putting your IC pipes on and before you clamp them down, coat the pipe and the inside of the rubber withn aresol hairspray. This is the trick I used when I was putting together both of my turbo kits on my Mazda. The hairspray lubes it up but when it dries creates an excellant seal. When I took my turbo kit apart I had to damn near put the **** in a vice to get it off, and never once had IC piping pop off.
Done..

BTW I'm running this FMIC on a OTS txs map and a vf39 with no problems at all.
* Registered users of the site do not see these ads.
WRX-ERROR is offline   Reply With Quote